Helpful Hints for Replacing a Cutlass Bearing
The drive shaft log of any vessel has cutlass bearing which is made with brass and a grooved lining from the inside and which is lubricated by the water that penetrates the grooves when it is rotating, this.
It does not matter the number of times that you use your boat, but you must at some point change the cutlass bearing. As soon as you realize it is time to make the cutlass bearing change you may find it hidden in the woodwork of the boat or some distance away from the keel.
Removing the cutlass bearing is not challenging however your hands will get dirty. Keep reading this article to know how to replace a cutlass bearing, now.
The first thing you should do is to locate the set screws and remove them. The area where you will find the layer of crud and marine is where the set screws are hidden in most cases. Don’t forget that other boat manufacturers do not use set screws. If you notice your boat does not have the set screws then do not waste any more time looking for them.
Of course you will have to cut the bearing. If you don’t have a Sawzall with you, then a hacksaw should help you to cut the cutlass bearing. Using the Sawzall tool is something that requires you to have enough experience on how to use it.
Bending the cutlass bearing is the next step. You can bend the cutlass bearing to the inner side using a cold chisel and a hammer so that you reach the other side where you have made a cut. Avoid using a lot of force when hitting the cutlass bearing so that it can bend. When you forcefully bend the cutlass bearing, you risk damaging the strut of the boat.
Put a maple dowel where you have created a space by bending the boat’s cutlass bearing inside and with a hammer slit it opens up to the other end. Do not use metal tools to slit open the cutlass bearing up to its length. The interior of the strut may get damaged by so doing.
Finally, remove the cutlass bearing. Do this with a pair of pliers to hold and remove the bearing. Install a new cutlass bearing after you clean the strut’s surface. After you remove the old cutlass bearing, cleaning the surface of the strut, and want to install a new cutlass bearing bought from Propeller Depot, make sure enter the acme props in a straight line.
If the ramrod strut is forced and not straight it, you may damage it. So that the ramrod of the strut can go in straight use some grease on the cutlass bearing to help it to slide in easily.
Suggested Post: official source